All 3 bolts on my carrier bearing worked with ze install!

[My_Probe_is_faster]

I know everyone I read about has trouble with the carrier bearing not bolting up properly to the ZE block, but when I did my install a week ago, all 3 lined up perfectly.

:shrug:

My car is a '93, might have something to do with it. Just letting everyone know, maybe this has happened before, but I was unaware of it.

Nick

[David Coleman]

Mine worked fine too. :darin:

[rotten97]

my ze came with a carier bearing and intermediate shaft ,fit right in my tranny .

[My_Probe_is_faster]

Hmmmph, and I thought only one bolt lined up for everyone!

Guess I'm not special :(

Nick

[pgt4speed]

Your car is a 93...that is why.....

Both ATX and MTX...mine lined up....both atx and mtx parts were from a 93 PGT :darin:

[Midnight ProbeGT]

i have a 94...and only one lines up, and well that fell out about a week ago. And nothing good came of it. My whole intermidiate shaft backed outta my tranny. :no: Uhh...but if anyone has a fix for only one bolt fitting...please let me know!! I'm not going through all that again!


ßill

[pgt4speed]

Originally posted by Midnight ProbeGT
Uhh...but if anyone has a fix for only one bolt fitting...please let me know!! I'm not going through all that again!


ßill

Get an intermediate shaft and bearing from a 93 PGT and you problems will be solved :thup:

Or

Put your engine parts(pistons, cams, crap) on a 94-97 2.5L block...

or

Throw in a Complete 94-97 Engine

Whichever you think would be more entertaining :tup:

[4U2Envy]

I have a 95 pgt. Only one (the the passenger side) hole lined up. My ZE block didnt have a match to the top hole. My Intermediate shaft only had two holes drilled. The top and the passenger side. The drivers side hole was not drilled. I do not know why it wasnt drill since the 03 block had a threaded hole to match.
What i did was use my original intermediate shaft and drilled the missing hole. It was easy to line up. The 03 shaft had clean spots where it met the block and darker spots where it didnt. A perfect circle to drill.
Now i have two bolts, the driver and passenger side.
Wade

[probesport_gt]

mine is a 94 and I am sure with my luck 1 will line up:tup:

[FWP!]

Only one will line up for those of you with this problem, then all you have to do which is what I did a few years ago is drill a hole through the bearing mount plate (the part that sits on the block) where it bows out on the one side because right behind there is a hole lined up with threads for a 14mm bolt just like the other ones.