thread: czt engine kit?
August 18th, 2005, 08:38 PM   #26
rurockn
Donating Member
 
 
: Jul 2001
: Texas
: 38
: 2,265
0.040 over is insane, the machine shop I worked at for a brief time wouldn't cut a crank past 0.020 for insurance liability reasons, 'most' cranks should be re-hardened after that cut.

http://forums.probetalk.com/showthread.php?t=1701168188
__________________
1994 PGT MS2 LC-1 370cc 190lph KLZE intake ported heads Turbonetics T4 2.5" Magnaflow STS MX3 flywheel ceramic clutch, 355fwhp ** sold
1980 Fairmont 4-door, S472, Megasquirt, 351C, 678rwhp.
2003 Mach 1, FR500 engine, 372rwhp w/out spray.
2003 Escape, slow.