I did not find a dealer yet jmmdm2. My project hit a slight snag with the MS6 master cylinder and brake booster. I need to cut and weld the firewall for it to fit. Even tho its no more than a days work, i still need to find a welder and prepare a bit before i can get it done.
For the rears i was thinking about "cheating" and fit the OEM ebrake cables. If i mount the left side caliper on the right side, and right side caliper on the left side, i think the cables will fit. This will make it hard to bleed them, because the bleeding valve weel be pointing down. So i am thinking of not mounting them, but stick a piece of wood between the pads, bleed them properly while holding them the right way, remove the wood and mount the bled caliper to the hub.
For the rears i was thinking about "cheating" and fit the OEM ebrake cables. If i mount the left side caliper on the right side, and right side caliper on the left side, i think the cables will fit. This will make it hard to bleed them, because the bleeding valve weel be pointing down. So i am thinking of not mounting them, but stick a piece of wood between the pads, bleed them properly while holding them the right way, remove the wood and mount the bled caliper to the hub.
Comment