How to setup launch control on PNPMS?

[KING6]

Because instead of doing one set of spark cuts, it now ramps up how many sparks are cut as you go from the soft limit to a total cut at the hard limit.

Matt, do you have a link to any information on this that I can read to set this up correctly?

As the settings were, I could only build about 1psi very slowly on either spark/fuel cut and either timing retard -5.0 or 5.0. That wasent the case prior to the new firmware, I could get up to 4-5psi very quickly on fuel cut and much higher on spark cut.

[Matt Cramer]

Launch control settings are here:

http://www.msextra.com/doc/pdf/html/...e-3.3-141.html