I cant find anywhere around here to get my car to pass inspection if it doesnt have functional reverse lights and if it will still start in any gear other than neutral. These are common problems after the swap, and from what I read people have been able to fix them. I found the plug & wiring for the reverse switch/sensor on the front of the tranny, it has two wires coming off of it and the plug isnt attached to anything on the atx wiring harness. Apparently I have to splice those wires in somewhere, the NTS.. the big orange plug that used to be on top of the tranny.. to get the reverse lights to work. Does anyone know which pin #'s I can splice them into, or does it have to go into the wiring? Also... what about the car starting in gear, has anyone gotten around that?
Sorry to ask an mtx related question in here, but I figured this would be the most appropriate forum for the info.
mark said:
well i simpley hooked the reverse wires from the NTS (nutral safety switch) to the reverse switch on the trans , BTW the reverse switch is located on the front of the trans , and it dosn't matter what way you hook the wires up .
make sure you use a weather pack type conector .
the wire colors are
r/y and b/y
can anyone explain that in more detail? I dont have the car here to look at as a reference, but I need it working ASAP. Thanks everyone.
Sorry to ask an mtx related question in here, but I figured this would be the most appropriate forum for the info.
mark said:
well i simpley hooked the reverse wires from the NTS (nutral safety switch) to the reverse switch on the trans , BTW the reverse switch is located on the front of the trans , and it dosn't matter what way you hook the wires up .
make sure you use a weather pack type conector .
the wire colors are
r/y and b/y
can anyone explain that in more detail? I dont have the car here to look at as a reference, but I need it working ASAP. Thanks everyone.
Comment