Seeing whats out there for custom manifolds. If you made one or know of any that are out there feel free to post them. Im currently looking to make one that will fit under the hood. Gerry Sicas probe manifold is the insperation but not sure even his clears a stock hood.
Announcement
Collapse
No announcement yet.
Custom Intake Manifolds
Collapse
X
-
Heres my idea for a manifold to overcome ITBS sticking out the hood. Just a rough drawing but its based off some other manifolds out there. Should be about 4.5 - 4.9L manifold with 4 inch runners. I havent got a motor in to check if the forward plenum will clear the hood or not but the rear should based off the stock manifold height.
https://i.imgur.com/BOPwHXW.jpgLast edited by keith_ze; January 24, 2021, 01:13 PM.mx3, ze swap, SS autochrome headers, 2.5 inch exhaust, custom made CAI, AWR motor mounts, interprep valve springs, n/a 218 race grind colt cams, street PnP, thermal spacers.
-
Did a bit of test fitting on the manifold on another motor today and it looks like the rear plenum will clear the hood for sure but am not to sure about the forward plenum it will obviously have to sit the same height as the rear but with the slope in the hood im not sure if it will clear in that area. might toss the motor in and see just how much room there is under the hood in that area.mx3, ze swap, SS autochrome headers, 2.5 inch exhaust, custom made CAI, AWR motor mounts, interprep valve springs, n/a 218 race grind colt cams, street PnP, thermal spacers.
Comment
Comment