So I had a thread about my idle issues. Well with a new pcv valve and grommet I think I have that mostly corrected. Now I have a new issue I replaced my TPS (throttle position sensor) do to bouncing RPMs with partial throttle. Now I still have the bouncing and when letting off the throttle below 2000 RPM I get a severe jerk.
Decided to unplug it for the rest of my drive today and both the jerking and bouncing is nearly gone. So at this point I wanted some input on whether I should try a third TPS or is the problem most likely in the wiring to the ECU ?
Side note the new TPS could not be set via the fan trick I did adjust it via volt meter to .60 volts
Decided to unplug it for the rest of my drive today and both the jerking and bouncing is nearly gone. So at this point I wanted some input on whether I should try a third TPS or is the problem most likely in the wiring to the ECU ?
Side note the new TPS could not be set via the fan trick I did adjust it via volt meter to .60 volts
Comment