View Single Post
Old September 14th, 2017, 01:07 PM   #23
PT Regular
Join Date: Jul 2007
Location: Long Island, NY
Age: 36
Posts: 605

I replaced the slave cylinder. Bled it.
Put everything together. Started the engine after more then half a year sitting. It started with some squealing and smoke. But then smoke cleared and engine ran with normal idle.

When pressing the clutch pedal it squeals. And engine starts to stall.

I am not able to switch gears when engine is running.

Can it be that I didn't bleed enough and it is not pressing far enough to separate clutch plate and let me switch gears?

I know my throwout bearing is bad, but can it be THE problem or something else may be cooperating with it not letting me switch gears?
iraklic is offline   Reply With Quote