Thread: Tps?!?
View Single Post
Old March 20th, 2017, 03:43 PM   #1
93lazerpgt
Slow Learner
 
Join Date: May 2016
Posts: 48
Tps?!?

So I had a thread about my idle issues. Well with a new pcv valve and grommet I think I have that mostly corrected. Now I have a new issue I replaced my TPS (throttle position sensor) do to bouncing RPMs with partial throttle. Now I still have the bouncing and when letting off the throttle below 2000 RPM I get a severe jerk.

Decided to unplug it for the rest of my drive today and both the jerking and bouncing is nearly gone. So at this point I wanted some input on whether I should try a third TPS or is the problem most likely in the wiring to the ECU ?

Side note the new TPS could not be set via the fan trick I did adjust it via volt meter to .60 volts
93lazerpgt is offline   Reply With Quote