If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Gearbox is a Weddle HV1 4 speed with a 10" crown wheel.
Valve cover was just me playing with my new welder.
Engine Klde
Bored 0.060 with diamond pistons (thanks to jmmdm2 )
H beam rods ( thanks to rurockn )
Ferrea +1mm valves, springs and retainers
Combustion chambers unshrouded to larger bore
Inlet ports filled and ported to match itb's
Exhaust ported
Peterson 3 stage oil pump
Oil galleries enlarged and intersections radiused
Balanced
10.7:1 comp
S2000 Honda injectors
MS3 extra with canbus 6x EGT probes
Oil pump runs at half engine speed and has cam hall sensor mounted on it.
Crank now has 12 tooth wheel (use to be 36-1 )
If the belt comes off the engine will lose sink and stop, I hope.
What size primarys for the headers did you go with on this?
Last edited by keith_ze; November 29, 2021, 06:58 PM.
mx3, ze swap, SS autochrome headers, 2.5 inch exhaust, custom made CAI, AWR motor mounts, interprep valve springs, n/a 218 race grind colt cams, street PnP, thermal spacers.
Comment