Announcement

Collapse
No announcement yet.

It's finally out! MegaSquirt PNP for '93-'95 KLDE and KLZE models!

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • It's finally out! MegaSquirt PNP for '93-'95 KLDE and KLZE models!

    MegaSquirt PNP for '93-'95 Probe / MX6 with KLDE or KLZE V6



    Thanks to the Probe and MX6 community for your support in getting this made! This is the first MSPNP to come about as a result of a MSPNP On Demand group buy. Here's a rundown of what this plug and play tunable ECU can do.

    MegaSquirtPNP Model #MK9395 Features

    1993-1995 USDM Ford Probe, Mazda MX6, or Mazda 626 w/ KLDE V6 and manual tranny

    Also fits 1992-1994 Mazda MX3 and KLZE swaps that use an OBD1 KL-series ECU.

    Easy to Use and Install!

    Fully Plug and Play Installation - No wiring required for basic functionality. Average install time is under 1 hour!
    2.5 V6 base maps is pre-loaded to help your engine start on the first turn of the key
    Real time tuning and data logging with a laptop connection
    Supports most aftermarket wideband sensors
    Fully Tunable Engine Control!

    16x16 Fuel Tables allow high resolution tuning
    12x12 Ignition Tables
    Multiple Acceleration enrichment strategies
    Closed Loop Idle Speed Control
    Air Conditioner Control
    VRIS control for both high speed and low speed butterflies
    Two stage fan control
    Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
    Allows removal of stock airflow meter
    Advanced Feature Set (Included!)

    12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
    Built-in 2-step rev limiter / launch control with flat shift
    Real time barometric correction
    Internal 4-bar MAP sensor reads up to 44PSI of boost
    Overboost protection
    Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
    Knock sensor input with adjustable sensitivity
    Headphone output for knock sensor - listen for knock while you tune!
    Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
    Input for flex fuel sensor - switch between E85 and gasoline on the fly!
    CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless!


    What you get in the box:

    MegaSquirtPNP MK9395 ECU

    MSPNP RS232 serial tuning cable, 6' (USB adapter sold separately, if needed)

    Tuning Software and Documentation CD

    6' Vacuum Hose for MAP Signal and 'T' fitting

    Four Screws for ECU mounting
    Matt at DIYAutoTune.com
    My PM box fills up fast - it's much better to email me at websales@diyautotune.com

  • #2
    NICE!!!! Getting this for my Birthday fo sho!!!!
    http://i1276.photobucket.com/albums/...GIFs/plane.gif

    Comment


    • #3
      Hoe much is this going for ?
      96 probe gt KLZE with a new ZE Gutted and junked
      94 probe gt sold,93 probe gt sold
      first 96 probe gt KLZE sold
      NEW 93 pgt KLZE swapped. Boosted axed and sold
      2004 srt4 on 22 psi the dd

      Comment


      • #4
        799$ look on da site yo lol
        95 pgt boosted 8 psi slowly tuning with help
        93pgt with 44k original miles sold...
        93pgt 95k auto part out as of 1/5/12 pm me for parts

        Comment


        • #5
          Got yea was to lazy
          96 probe gt KLZE with a new ZE Gutted and junked
          94 probe gt sold,93 probe gt sold
          first 96 probe gt KLZE sold
          NEW 93 pgt KLZE swapped. Boosted axed and sold
          2004 srt4 on 22 psi the dd

          Comment


          • #6
            Seen this is a gen2 but what are the odds of a 96-97 plug and play? obdII compliant
            Last edited by alazare619; September 26, 2012, 02:49 AM.

            Comment


            • #7
              Originally posted by alazare619 View Post
              Seen this is a gen2 but what are the odds of a 96-97 plug and play? obdII compliant
              Odds of a '96-'97 MSPNP: What are the odds 20 people would go for a group buy? The connectors are more expensive and we'd have to order a batch of them since we don't have them on hand. But if there's enough interest, we can make it happen.

              Odds of the MSPNP outputting OBD2 codes: Zero.
              Matt at DIYAutoTune.com
              My PM box fills up fast - it's much better to email me at websales@diyautotune.com

              Comment


              • #8
                Follow up: I've started a sign-up thread here for anyone interested in a '96-'97 MSPNP.
                Matt at DIYAutoTune.com
                My PM box fills up fast - it's much better to email me at websales@diyautotune.com

                Comment


                • #9
                  deff gonna have to get one of these after I get my taxes done. hopefully sooner lol.
                  THE ONLY REASON I'M DRIVING THIS FAST IS BECAUSE I REALLY HAVE TO POOP

                  Comment

                  Working...
                  X