according to http://img64.imageshack.us/img64/8545/HEI.jpg link, where the heck does G go if i terminate 5 and 6. The way i wired it from the project mazda site i have G tapped into #6 with nothing cut/terminated nor anything with the internals of the distributor messed at all. Then again i have a 93, but from reading way too many pages of this thread it seemed 93-94 were very similar and 95 on is where differences occur. I guess i might as well go for the external coil Mod if i am going to be taking the intake and dist. cap off again and before the ignitor bites it anyways. so i planned to folllow the directions from the Project Mazda site for the external coil too but since the HEI diagram there is diff from the one here, is there something more clear then the kiddie artwork thats on that site that works for a 93.
Basically here's what i have,
-sanded the area immediately behind the drivers headlight to metal and mounted the HEI mod there with the gooo on the back....did not use bracket, just directly to sanded metal frame...is this going to screw me up?
-W and the screw hole are grounded at the same point right by the battery ground but not the exact nut as the battery ground by diagnostics box
-My G tapped into the wire of the 6 wire harness that is closest to firewall when connected.
-My C tapped into wire of 3 wire harness that is farthest from friewall when connected
-And my B to the wire closest to firewall of 3 wire harness.
-internals and cap of dist. left untouched
so where have i gone wrong in the above steps other then the mentioned confusion about the G should be wired?
Basically here's what i have,
-sanded the area immediately behind the drivers headlight to metal and mounted the HEI mod there with the gooo on the back....did not use bracket, just directly to sanded metal frame...is this going to screw me up?
-W and the screw hole are grounded at the same point right by the battery ground but not the exact nut as the battery ground by diagnostics box
-My G tapped into the wire of the 6 wire harness that is closest to firewall when connected.
-My C tapped into wire of 3 wire harness that is farthest from friewall when connected
-And my B to the wire closest to firewall of 3 wire harness.
-internals and cap of dist. left untouched
so where have i gone wrong in the above steps other then the mentioned confusion about the G should be wired?
Comment