MS2/Extra 2.0.1->3.3.3 update help

[ddrop]

Hey Guys

I recently tried updating the firmware in my Megasquirt 2 from 2.0.1 to 3.3.3. Since doing so, the car barely runs. It seems to start up and idle ok at first but then gets worse. Giving the car a little gas makes it miss/stall out. The release notes mention about having to change the barometric correction. I tried changing this with no luck.

I even tried loading the old firmware back on but got an error:
http://www.filedropper.com/20150703200537

here is my msq from 2.0.1:
http://www.filedropper.com/probe2015-06-25183329

here is my current (3.3.3) msq:
http://www.filedropper.com/probe2015-07-03112306


Any ideas on what I'm missing here or how to get the old firmware back on?

I'm running a Megasquirt 2 v3 ,coil pack (non edis), Supra low imp 440cc injectors.

Thanks,

[red6]

data log it and post it on ms forums and here, might get better help

[ddrop]

Here is the data log:
http://www.filedropper.com/2015-07-04081554

If i try to bring in the msq from the old load this is the log i get:
http://www.filedropper.com/mismatch_1

[red6]

post it on ms forums