no. As stated in the first post in the item list of things you will need. new CV's axles/shafts or whatever you wish to call them will be required for the swap.
No, the existing ecu on mine does the job, addining an extra wire into the ecu for M/T ground smoothe's the idle out as well.
You just disconnect the TCM loom under the centre console to remove the CEL.
you only jumper the neatral postion on the loom. ie connect pins 6 & 9 together. the other connection you will need in that same harness is the reversing sensor.
Originally posted by PW_93mx6ls
View Post
You just disconnect the TCM loom under the centre console to remove the CEL.
you only jumper the neatral postion on the loom. ie connect pins 6 & 9 together. the other connection you will need in that same harness is the reversing sensor.
Comment