If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hotshot makes a CAI for ATXers. That's what I am going with. Go to www.probeparts.comwww.spmotorsports.com or www.corksport.com I know there are others... but I don't remember. The cheapest I have seen them is like $180. Yes.. expensive.. but its worth it, so I've heard.
But the ones on ebay do not come with the elbow,
I was going to use a prelude one
but I read it couldnt be done to an atx.
And that's because the piping needs to be longer to
extend pass our tranny.
So basicly I would buy one from ebay, But I need an elbow.
Because I cant use that ugly @ss stock hosing!
ewww I shudder at the thought!
I need something polished in my engine bay,
I cant go with pvc piping neither. - No offense to you pvc guys!
I mean I dont mind buying a PRM.
Worse comes to worse ill get a hotshot.
I just cant do it right now, I already spent a ton on parts.
Im adding stuff everyday...so I was looking to cut corners.
Artist, Writer, Photographer, Video Producer, Daddy!
You could always buy one for a Civic or Integra and cut it at the bend and use it. The one I bought for my 4cyl ATX would not work as a CAI so I parted it and now I have a Chrome Elbow and a warm air intake that almost hits the radiator hose. Not to bad either.
Originally posted by QuadCam_GT go to home depot, buy some 2.5" PVC or ABS. Cut, fit, paint with high temp engine paint. It'll cost you all of $10-$15.
I did that too. Then, I realized that it sucked, so I bought a Hotshot. Also, the hotshot matches my clean engine.
Jesus is the remedy Black '94 GT DE/ZE hyrbid, too many parts to list Black'89 MX-6 GT AWS: T3/T4 turbo, 3" exhaust, big brakes, FD's, K-sports, FD's, plus much more... Ebony Pearl'95 Subaru SVX LSi home of: BontragerWerks 22mm RSB #001
Originally posted by CrimSon_ReD But the ones on ebay do not come with the elbow,
I was going to use a prelude one
but I read it couldnt be done to an atx.
And that's because the piping needs to be longer to
extend pass our tranny.
The prelude intake I got for my '93 had MORE than enough piping to work on my '95, $35 on Ebay.
Is there not enough room on just the GT ATX or is it the SE ATX as well? And i read that an intake for a prelude would work, what generation prelude and what model probe will it work for (gt/se)?
Comment