Bolt-on Big brake kit

[hoogs]

protege rear brakes, or 98+ 626 and 626 cables? If you are sure then I'll go ahead and order them too

the 98+ 626 rear brakes work with the factory ebrake cable from the probe, Mono is pretty sure that the 626 ebrake cables will work with mazda6 rear brakes

[FIS]

I think i came up with the 626 cables working over a year ago at this point. And sadly it still hasnt been tried. Every time i see this thread bumped, im just hoping someone has finally given it a try.

Last I heard Zepticon was thinking on trying the cables on his MS6 brakes, but he needs the e-brake mounting for them on them in order to try first "/

[MonoxideChild]

^
He's has those for a few months. I was gonna source him some, but he got back to me that he had already found them.

[ScottD961]

So this week I have got to order more parts ! LOL

[directorgtr]

Very interesting thread! This has officially been put on my 'tuudoo' list

[ScottD961]

Yes me too. I need to get the fronts on already

[SlickX]

Nice, may do it in the future. (:

[RacerXR]

I'm running the Mazda Speed6 rotors/bracket/calipers/pads up front and 98+ 626 rotors/brackets in back on my 24 hrs of LeMons/Chumpcar '93 626. I'll be moving this setup to the '94 Prode SE I bought later this year.

One set of Hawk DTC-60 pads have lasted 3 full races in the Speed6 calipers to date. I doubt I will get another full race out of them. But, that's much better than the single race I was getting from the original rotors/calipers.

[RacerXR]

Hardest part to find was the Mazda Speed6 brackets. I ended up buy those direct from the dealer. They were the most expensive parts.

[RacerXR]

I also used the 626 flex brake lines. The fit is kinda tight. But they work.

https://scontent-b-dfw.xx.fbcdn.net/...20289142_n.jpg

[MonoxideChild]

Yea, using your original lines are best. The 6 ones can be used, but dont fit as nicely, and the mounting spots are a little off.

[klze662]

08 fusions done 18" wheels

http://i48.photobucket.com/albums/f2...ps35e8daad.jpg

[Zepticon]

98+ Brake cables on MS6 rear brakes

So, i tested the hypothesis that the 98+ rear e-brake cables will fit the rear brakes on the 626/probe/MX6, and they do. But thats a very close call.
I would say it is not the ideal solution, but at the time i think it is good enough to drive with. Hopefully i will get a bit more length when i lower the car down from the stands.

I am going to research if there are any longer cables available than the 98+ ones, for more wiggleroom.

Pictures:
http://img.photobucket.com/albums/v6...n/IMG_3647.jpg

http://img.photobucket.com/albums/v6...n/IMG_3648.jpg

http://img.photobucket.com/albums/v6...n/IMG_3649.jpg

http://img.photobucket.com/albums/v6...n/IMG_3650.jpg

[Gt-Addict]

finally someone did this!

good job.

[MonoxideChild]

Thank You! That only took like 2 years for someone to finally try.