Working on my X-member

[neonman]

Here is the start of our new crossmember. When my motor mount plate is finished it will be tied into the cage. Can you say no more broken trannies.

[DOHCtimes2]

What headers are those? Sorry it is off topic...

[Triumph1902]

Thats no crossmember thats an engine cradle!

[neonman]

What headers are those? Sorry it is off topic...

PMO of course

[Corvander]

to innovation, could you explain how this works, what part of the trans do you have to worry about breaking, also would that hold up during an accident?

[neonman]

Everybody that has spent any time on PT should know about our tranny problems. As far as holding up in a accident who knows. I would say that it will hold up better than any of the factory stamped steel.

[soulstylee]

Is this part of the chasis you are making yourself?

[neonman]

There also will be built in traction bars

[1slowblackze]

just gonna be sick

[neonman]

Is this part of the chasis you are making yourself?

Hell I'll sell these for sure How much will they cost? Don't know. Will anybody buy them? A few hardcore people.

[Mx6kRaZy_03]

Hey i know this is off topic- But you said you made and were going to sell a 3" Exhaust kit. This still happening? I'm kinda needing one.


Adam

[Triumph1902]

There also will be built in traction bars

I was just thinking that^^^

Do you have any ballpark price in mind? This is something I might have to save for.

[neonman]

I was just thinking that^^^

Do you have any ballpark price in mind? This is something I might have to save for.

I'll let everyone know over the weekend

[Scott]

Please correct me if I'm wrong, but they don't look like they'll work with your existing traction bars.

BTW...very nice looking headers!

[Rayman]

ground clearance?

looks good, too bad i got too many pipes down there and my car has like 2-3" clearance at the lowest point under the x-member